A stepper motor control is a specially constructed DC motor. It has 4 windings arranged such that instead of running in the usual continuous fashion the motor rotates in precise steps, from one fixed position to another. The common step sizes range from 0.9 to 30 degrees. The stepping action is achieved by proper combination
Microprocessor Based Stepper Motor Control Read More »
Microcontrollers as the name suggests, are small controllers. They are like single chip computers that often embedded into other systems to function as processing / controlling unit, microcontrollers are single chip microcomputers. A microcontroller has a CPU (a microprocessor) in addition to a fixed amount of RAM, ROM and I/O parts and a timer on
Microcontroller – Introduction, Advantages, Features Read More »
Microprocessor – controlled temperature system is used to Read the temperature in a room Display the temperature at LCD/LED panel Turn-on a fan if the temperature is above the limit. Turn-on a heater if the temperature is below the limit. This system has a temperature sensor as an input device to sense room temperature and
Microprocessor Controlled Temperature System Read More »
Memory Interfacing While executing a program, the microprocessor needs to access memory frequently to read instruction code and data stored in memory; the interfacing circuit enables that access. Memory has some signal requirements to write into and read from its registers. Similary, the microprocessor initiates a set of signals when it wants to read from
Memory Interfacing and I/O Interfacing Read More »
The IOP is similar to a CPU except that it is designed to handle the details of I/O processing, Unlike the DMA controller that must be set up entirely by the CPU, the IOP can fetch and execute its own instructions. IOP instructions are specifically designed to facilitate I/O transfers. In addition, the IOP can
Communication Between 8086 and 8089 Read More »
General The primary energy sources for the production of electricity have been based on the combustion of fossil fuels (coal, oil, and natural gas) to produce steam to drive turbines. Alternatively, rivers are impounded to provide water to drive hydraulic turbines. A third principal source is the heat of nuclear reaction by uranium to produce
Primary Sources of Electric Power Read More »
Superconducting Magnetic Energy Storage – Electricity (dc) can be stored in magnetic fields, wherein the energy stored is proportional to the inductance times the square of the current. An energy storage system based on magnetic would involve an ac-dc-ac converter system (like batteries) and a large coil of a superconductor (a niobium-titanium alloy). To achieve
Superconducting Magnetic Energy Storage – Electrical Energy Storage Read More »
Flywheels : Mechanical energy may be stored in the form of kinetic or potential energy. A flywheel, in essence, is a mechanical battery simply mass rotating about an axis. Although the use of the flywheel as a kinetic energy storage device is well known, it has not, until recently, been considered practical to build flywheels
Mechanical Energy Storage – Flywheels, Pumped Storage, Compressed Air Read More »
Batteries : The most traditional of all energy storage for power system is the electrochemical energy storage (EES). The major classification can be made in three categories. They are primary batteries, secondary batteries, and fuel cells. The common feature of these devices is primarily that stored chemical energy is converted into electrical energy. Although the
Electrochemical Energy Storage – Pedagogy Zone Read More »
Solar electric or PV systems convert some of the energy in sunlight directly into electricity. PV cells are made primarily of silicon, the second most abundant element in the earth’s crust and the same semiconductor material used for computers. When the silicon is combined with one or more other materials, it exhibits unique electrical properties
Solar Photovoltaic : Technologies and Applications Read More »